Cisco Systems OL-21636-01 Security Camera User Manual


 
4-18
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
Chapter 4 Managing a FlexUNI/EVC Ethernet Service Request
Setting the Service Request Details
Step 30 If you checked the PW Tunnel Selection check box, enter the TE tunnel ID in the Interface Tunnel text
field.
Usage notes:
ISC uses the tunnel information to create and provision a pseudowire class that describes the
pseudowire connection between two N-PEs. This pseudowire class can be shared by more than one
pseudowire, as long as the pseudowires share the same tunnel ID and remote loopback address.
During service request creation, ISC does not check the validity of the tunnel ID number. That is,
ISC does not verify the existence of the tunnel.
The Interface Tunnel attribute is not supported for IOS XR devices.
Step 31 Check the AutoPick Bridge Group Name check box to have ISC autopick the bridge group name during
service request creation.
If this check box is unchecked, you are prompted to specify a bridge group name during service request
creation (see the next step).
Usage notes:
This attribute only displays for IOS XR devices.
If the AutoPick Bridge Group Name check box is unchecked, enter an bridge group name in the
Bridge Group Name text field.
The AutoPick Bridge Group Name and Bridge Group Name attributes only appear if Configure
Bridge Domain was enabled in the EVC Service Request Editor window earlier in the service
request workflow.
Step 32 Check the AutoPick Bridge Domain/VLAN ID check box to have ISC autopick the VLAN ID during
service request creation.
If this check box is unchecked, you are prompted to specify a VLAN ID during service request creation
(see the next step).
Usage notes:
AutoPick Bridge Domain/VLAN ID consumes a global VLAN ID on the device.
The bridge domain VLAN ID is picked from the existing ISC VLAN pool.
The AutoPick Bridge Domain/VLAN ID attribute appears for both Cisco 7600 and ASR 9000
devices. It will be displayed only for non-FlexUNI links.
Step 33 If the AutoPick Bridge Domain/VLAN ID check box is unchecked, enter an ID number in the Bridge
Domain/VLAN ID text field.
Usage notes:
If AutoPick Bridge Domain/VLAN ID is checked, this field is non-editable.
When a VLAN ID is manually allocated, ISC verifies the VLAN ID to see if it lies within ISC’s
VLAN ID pool. If the VLAN ID is in the pool but not allocated, the VLAN ID is allocated to the
service request. If the VLAN ID is in the pool and is already in use, ISC prompts you to allocate a
different VLAN ID. If the VLAN ID lies outside of the ISC VLAN ID pool, ISC does not perform
any verification about whether the VLAN ID allocated. The operator must ensure the VLAN ID is
available.
The Bridge Domain/VLAN ID text field appears for both Cisco 7600 and ASR 9000 devices. It will
be displayed only for non-FlexUNI links.
Step 34 Check the AutoPick Bridge Domain Name check box to have ISC autopick the bridge domain name
during service request creation.