Filter
Top Products
2-90
Section 2— Control Panel Descriptions
Aux Bus Selection
Aux buses 1 through 5 can be used as simple video routing
aux buses or for sending video and key to an external digital
device (DPM). Each bus consists of an “A” bus and a “B” bus
under E-MEM control. The “A” buses are for video only; the
“B” buses may be configured for either video or key.
To use the Aux bus as a simple routing bus:
For an “A” bus, press the appropriate Bus Delegate button to
select the desired Aux bus, then select any primary or re-entry
source on the PVW AUX row. To select a “B” bus, hold down
the Bus Delegate button while selecting the primary or re-
entry source.
To use an Aux bus for “effects looping” operation:
Select the layer of the desired M/E on the Effects Send group
of buttons. This causes the selected M/E output to be sent out
the Aux bus output. Concurrently, a primary switcher input
(that has previously been chosen to receive the return video
from the DPM or other external device) is automatically
routed to the chosen mixer layer for insertion of the processed
video. The primary input to be used for the return path is set
up in the Configuration menu.
.
.
.
Aux
5
Aux
1