Filter
Top Products
2-54
Section 2— Control Panel Descriptions
NOTE:
Cuts, Inserts, and Pastes cannot be performed on any locked
level of an E-MEM register.
Only those levels that are delegated are affected by timeline editing.
When ENABLES is selected in the Timeline menu or the main
Keyframe menu, all enabled levels are also delegated; thus all
levels are affected. When DELEGATES is selected in the menu, only
specified enabled levels are delegated; all other enabled levels are
enabled but not delegated.
NOTE:
The DELEGATES selection in the Timeline menu and main
Keyframe menu is discussed in the Effects Editing section of this manual.
Constant Duration Off
The following pages describe the operation of the keyframe
insertion/deletion functions when Constant Duration mode is not
selected (CONST DUR button at low tally) and ENABLES is selected
in the Timeline menu or main Keyframe menu.
NOTE:
Refer to the CONST DUR button description for the operation of
keyframe insertions and deletions in Constant Duration mode.
When CONST DUR is off, the overall duration of the effect is the sum of
the durations of the individual keyframes (on the Master Timeline).
Adding or deleting keyframes or changing the duration of one or more
keyframes may change the overall duration of the effect.
On a Keyframe. When the Time Cursor is positioned on a Master
Timeline keyframe, INSeRT BEFORe inserts a keyframe and its
duration into each delegated level just prior to the current
keyframe. All subsequent keyframes are “rippled” (pushed out)
in time by an amount equal to the newly inserted keyframe
duration. This increases the overall duration of the effect by the
duration of the inserted keyframe.
Insert
Before