Filter
Top Products
2-93
Preview/Aux Bus Source Select and Delegate Subpanel
1. To select Effects Send non-looping mode, first press the AUX
BUS
button on the main menu panel, and then press the PHYS
AUX SELECT
soft button to select the Aux Bus to be looped. With
the EFX LOOP MODE button select NO LOOP.
2. Select the Keyer output to be sent to the DPM by pressing one
of the EFFECTS SEND buttons on the PVW/AUX row of
buttons (M/E 1 A through M/E 2 Key 2).
NOTE:
The A and B bus selections apply only when in layered mode.
3. With one of the BUS DELEGATE buttons, select the (physical)
AUX BUS (1-2) that you want to use. With the switcher set up
as described previously for non-looping, the DPM output will
be routed to the previously-mapped crosspoint column on the
Source Select panel.
4. If the DPM output has been connected to a primary input and
mapped to one of the crosspoints, it may then be selected as a
source on any output bus on the Source Select panel.
Effects Send Loop with Frame Store
With previous software versions, the output of the Frame Store
option could not be returned to the M/E mixer via the effects send
loop.
With Software Release 5.2, the Frame Store may now be used with
the effects send loop to capture the output from a keyer and return
the frozen image to the mixer of the same M/E. This is similar to
using the effects send loop with an external DPM (Digital Picture
Manipulator).
NOTE:
You must have the Frame Store option and the Effects Send
option installed in order for this feature to operate.