Filter
Top Products
2-39
Effects Memory Subpanel
Keypad with Readout
The E-MEM keypad is used for effect recalls, and serves
as a numerical entry pad for the following buttons: TRAN
RATE
, LeaRN, LeaRN SEQ, LOCK, BANK, GET, and PUT.
(The last two of these buttons are located in the E-MEM
effect editing group of buttons.)
Pushing a numerical button at any time other than when
preceded by one of the above buttons recalls the
corresponding register within the current bank. To recall
a register in a different bank, enter: BANK, bank number,
register number
The alphanumeric readout at the top of the
E-MEM keypad provides status information
about E-MEM operations and registers.
During normal learn and recall operations, the current Bank and
Register values are displayed. If the register is locked, there is an
“L” shown at the left end of the display. Other messages on the E-
MEM readout include “NO CURRENT REG” at bootup, “NO
EMPTY REGS” if no register is available for a LeaRN• or PUT•
operation, and “REG IS LOCKED” if you attempt to put an effect
into a locked register. During gets and puts, the display provides
prompts asking you for the source or destination register.
NOTE:
Only areas which are enabled will be recalled. For more
information read Enable Buttons on page 2-47.
It is possible to have two different enabled levels recalled by two
different registers. In this case there are actually two current
registers, but only one can be shown in the display. The existence
of this condition is indicated by a “∆” between the apparent
current bank number and the apparent current register number
(for example, “B0∆REG 04”).
7
8
9
4
56
123
0
Tran
Rate
Undo
.
1345804-42224438
Seq
Bank
Effect
Dis
Bank 0
Bank 1
+/---
Lock
Learn
Trim
Enter
NO CURRENT REG