Filter
Top Products
3-33
External Interface Menu
DPM Setup Menu
From the External Interface Menu, press DPM I/F> to bring up the
DPM Setup Menu.
The DPM type, aux bus control, channel routing selection, effects
send delay, and control delay for each of (up to) four DPM devices
is indicated in the table in the display. The menu displayed
references a Model 2200-2i integrated DPM system.
NOTE:
For information on assigning aux buses to DPMs, be sure to
read “DPM Configurations” in the Startup section of the Model 2200
User Guide.
For Kaleidoscope:
1. Set the DPM TYPE to KSCOPE.
2. Turn the EFF SEND DELAY soft knob to select 2 fields. It is
important that this delay be set correctly.
DPM SETUP MENU
CONTROL DELAY
= 6 fields
DPM
TYPE
DEVICE
SELECT
DPM MAP
AUX BUSES >
KSCOPE
KRYSTAL
OTHER
NONE
DEVICE 1
DPM MAP
INPUTS >
NONE
NONE
NONE
2
2
2
DEVICE 2
DEVICE 3
DEVICE 4
EFF SEND DELAY
= 5 fields
config / extern if / dpm setup
DPM 2
none (no E-MEM control)
none (no E-MEM control)
0
0
0
E-MEM LEVELS
CONTROL
DELAY
EFF SEND
DELAY
WARNING: Changing DPM TYPE may change
channel routing, control devices and aux bus mapping.
DEVICE 1 INTERNAL 5
OFF
OFF
OFF
BOTH CHAN 1, CHAN 2, GLOBAL and CAMERA6
CHANNEL
ROUTING
SWR IN
SWR OUT
OFF
BOTH
INTERNAL