Filter
Top Products
3-50
Section 3 — Menu Descriptions
1. For the “5B” bus, select either VIDEO or KEY with the
appropriate soft button.
2. Press the AUX BUS SHAPING> button to select the Aux Bus
Shaping menu.
Press EXIT to return to the Peripheral Interface menu.
Aux Bus Shaping Menu
From the Aux Bus Format menu, press the AUX BUS Shaping>
button to display the Aux Bus Shaping menu.
The Aux Bus Shaping Menu allows you to select the output
configuration to be always shaped or always unshaped on aux buses
one and two. Thus the configuration should be set according to
the input needs of the external device connected to the aux bus.
The switcher then internally decides whether to turn on shaping
or unshaping circuitry according to the nature of the video/key
pair feeding the aux bus.
NOTE:
The output shaped/unshaped selections for the Aux Buses apply
only to the Aux 1 and Aux 2 outputs and only if the Effects Send option
is present. Without the circuitry on the Effects Send module, the aux bus
outputs simply pass whatever signal is present—either shaped or
unshaped.
1. Press the PHYS AUX SELECT button to select the physical aux
bus to be used in the effects send loop.
2. Set the VIDEO/KEY FMT
selections for Aux Buses 1 and 2 to
match the characteristic SHAPED or UNSHAPED expected by
the external devices connected to those outputs. These
settings control the states of the shapers and unshapers on the
Aux Bus outputs.