Filter
Top Products
2-62
Section 2— Control Panel Descriptions
Pressing STOP NEXT KF causes an effect to be stepped through,
one Master Timeline keyframe at a time. When on, STOP NEXT KF
causes run commands to last the duration of one keyframe, and
each lever arm transition to advance the run only one keyframe at
a time. The button is at high tally when the function is selected, at
low tally when enabled but not selected.
When HOLD INPUT is enabled (high tally), all crosspoints (video
and key) on all buses of the switcher are held. That is, the state of
the crosspoints do not change when an E-MEM recall is done. If
key memory is on at this time, the current keyer memory state is
also held. (See Recalling Effects on page 2-38 for information
about holding crosspoints on individual buses.)
Pressing the RUN button causes an effect to begin running from its
current position. The RUN button is also used to stop and resume
an effect during the run by acting as a run toggle button. The RUN
button lights during a run, then turns off when the run is
complete.
Stop
Next
KF
Hold
Input
Run