Filter
Top Products
2-34
Section 2— Control Panel Descriptions
Matte Delegation
Each matte subpanel has a MATTE SELect button used to select
which of the six matte generators that particular subpanel will
control. Above the MATTE SELECT button are six indicators,
which illuminate to show the current delegation at any given
time. Pressing the MATTE SELLECT button repeatedly cycles the
selection through all six matte generators. Holding the button
down causes it to cycle through the selections automatically until
the button is released. If the Borderline option is not installed in
Key 1 or Key 2, the K1 BORD and/or K2 BORD selections will be
skipped.
MATTE SELECT Indicators
The six indicator LEDs indicate delegation as follows:
K1 FILL and K2 FILL LEDs – Indicate that the matte subpanel is
delegated to one of the matte generators for a subpanel
determined by the key hole cutter. However, when the keyer is in
Video Fill mode, the matte is not visible. Matte fill is available
with all key types (LIN, LUM, CHR, PST PTTN).
K1 BORDer and K2 BORDer LEDs – Indicate that the matte
subpanel is delegated to a matte generator for adjusting the
characteristics of the key border matte in all Borderline modes.
(See the Keyer Subpanel description for related keyer buttons
BORDer, SHDW
, EXTRUDE, and OUTLINE.)
PRI WIPE LED – Indicates delegation of the matte generator for
controlling the transition wipe border matte. The PRI WIPE LED
also indicates that the M/E matte subpanel is delegated to create
the primary preset pattern border in preset pattern mode. (See the
PRI PST PTTN
button description under the Keyer Subpanel
topic.)
SEC WIPE LEDs – Indicates that the matte subpanel is delegated to
create the secondary preset pattern border in preset pattern mode
(see the SEC PST PTTN button description under the Keyer
Subpanel topic).
Matte
Select
K1 Fill K1 Border
K2 Fill K2 Border
Pri Wipe Sec Wipe