Filter
Top Products
2-47
Effects Memory Subpanel
Enable Buttons
The Enable buttons are located to the left of the keypad in the E-
MEM Subpanel and are used for enabling register levels. Each
register is partitioned into sections (or “levels”) corresponding to
the Enable buttons.
All register manipulation, including learn and recall operations,
affect only the enabled levels. This allows you to build
independent effects on each level and to recall the levels
independently.
For example, an effect using both M/E 1 and M/E 2 could be built
with both being enabled, and either the M/E 1 or M/E 2 part of
the effect could be recalled separately by enabling only one and
recalling the register. Conversely, separate effects built at
different times, in different levels of the same register, can be
recalled together by enabling both M/E 1 and M/E 2.
The
ME 1 and M/E 2 buttons are also used when setting transition
rates in the effects systems, as previously described (see TRAN
RATE
).
M/E 1 and M/E 2 enable the following areas for learn and recall
operations on a specific M/E: standard or layered mode
operation, crosspoint settings, transition settings, keyer settings,
masks and mattes, chroma key settings, wipes, positioner settings
and full additive mix (FAM) settings.
BKGD enables the two background matte generator settings
(BKGD 1 and BKGD 2 In the background subpanel) for learn and
recall operations, excluding matte wash.
Auto
Recall
Bkgd
M/E 2
Enable
All
Misc
Global
Chan 1
M/E 1
Camera
Chan 2
Enables
Auto
Run
M/E 1
M/E 2
Bkgd