Filter
Top Products
2-42
Section 2— Control Panel Descriptions
SEQ is used for creating automated register-recall sequences.
Create sequences with the following buttons and values
(parameters in angle brackets (<...>) are optional):
NOTE:
Only areas which are enabled will be recalled. For more
information read Enable Buttons on page 2-47.
SEQ, LRN,
register, <TRAN RATE>, <delay>,
register, <TRAN RATE>, <delay>,
..
...
LRN
The command syntax is defined below.
SEQ and LRN may be pressed in either order to start the
command sequence.
LRN must be pressed again to end the command sequence.
<TRAN RATE> and <DELAY>, in angle brackets, are optional.
(TRAN RATE) enables a user-defined delay to be introduced
between register recalls.
<DELAY> is a 1- to 3-digit number entered on the keypad that
specifies an amount of delay in TV frames. (If the number
entered is a 1- or 2-digit number, the entry must be terminated
by pressing ENTER.
REGISTER is any desired register number, as described
previously (that is, BANK, BANK NUMBER, REGISTER NUMBER).
Create a sequence loop by pressing the first register button as the
last register in the sequence.
Seq