Filter
Top Products
2-60
Section 2— Control Panel Descriptions
A new duration may be entered as follows on the E-MEM keypad:
S S S • F F • f ENTER
1
The keyframe duration is then applied to all delegated levels by
pressing MODify once.
The EFFect DUR button is provided for future editing operations.
PREV and NEXT are used to step the effect forward or backward to
the next keyframe on the Master Timeline.
When the PREV or NEXT button is pressed, it high-tallies for one-
half second to confirm the operation.
The PREV button is off at the beginning of an effect or if the effect
has zero or one keyframe. The NEXT button is off at the end of an
effect or when the effect has zero or one keyframe.
GO TO TIME enables positioning of the effect to a specific position
on the Master Timeline. When GO TO TIME is active, the desired
time is entered as follows on the E-MEM keypad:
SSS•FF•fENTER
where SSS=Seconds, FF=Frames, and f=field(s) of the desired
point in time
or as abbreviated above under KF DUR.
GO TO KF moves the Time Cursor to the specified keyframe on the
Master Timeline.
1. Not all digits are required for defining the time. The system will recognize the • button presses to de-
termine which digits are seconds, which are frames, and which are fields. For instance, to enter 2
seconds and 5 frames (65 frames or 130 fields), you would need only to enter:
2 • 5 ENTER
or • 6 5 ENTER
or • • 1 3 0 ENTER
In all of these cases, the display will show:
KF DUR 002:05.0
Effect
Dur
Next
Prev
Go To
Time
Go To
KF