Filter
Top Products
3-17
User Preferences
Define Defaults Menu
From the User Preferences menu, press the define defaults>
button to display the Define Defaults menu: This menu allows
you to change the default values that are stored in memory and
used when the switcher is turned on or the CLEAR WORK BUFR
button is pressed.
The Define Defaults menu selections are as follows:
M/E SELECT — Selects the M/E whose settings are to be used
during power-up. (Only one set of values is stored for the M/Es,
therefore both M/Es use the same values at boot-up.) The
switcher panel (including the selected M/E) is used to set up the
switcher default values.
SET DEFAULT — Enters the new default values.
GVG DEFAULT — Restores the factory-set default values to the
switcher.
Press exit to return to the User Preferences menu.
Press exit again to return to the Configuration menu.
DEFINE DEFAULTS MENU
ME1
config / user prefs / define defaults
M/E
SELECT
SET
DEFAULT
ME2
GVG
DEFAULT
Set Default State to Current Switcher State. All M/Es will use ME1 settings
Set Default State to GVG Factory Default.