Filter
Top Products
2-48
Section 2— Control Panel Descriptions
MISC enables the following user-defined areas for learn and recall
operations: frame store settings, peripheral settings, GPI settings,
aux bus settings, mask bus settings, preview bus settings, and
matte wash settings for Backgrounds 1 and 2. All aux buses
default to the MISC level unless assigned to a DPM level using the
Config/DPM Map Ports and Config/DPM Map Aux Buses
menus.
chan 1, chan 2, Global, and Camera enable parameters of the
channel 1, channel 2, channel 3, and channel 4 DPMs (Digital
Picture Manipulators) for learn and recall operations.
Pressing ENABLe ALL lights all Enable buttons if any or all of them
are not presently lit, or turns all Enable buttons off if all are
already lit. This action allows all enables to be turned off or on
with a maximum of two button presses.
ENABLe ALL may also be
used to enable all levels simultaneously when setting transition
rates (see the TRAN RATE button description).
AUTO ReCalL allows the state of the Enable buttons to be learned
or recalled as part of an effect.
If AUTO ReCalL is on while an effect is learned, the state of the
Enable buttons is learned as part of the effect. If AUTO ReCalL is off
while an effect is learned, the enables are not learned, and any
subsequent recall (even if AUTO ReCalL is on during the recall)
does not change the state of the enables.
If AUTO ReCalL is on during a recall, the enables (as learned) are
first recalled, then the resulting enabled portions of the switcher
are recalled. If AUTO ReCalL is off during a recall, the enables
remain as set on the Enable panel, and those parts of the effect are
recalled.
AUTO RUN enables effect Recall-and-Run operations. When
AUTO RUN is active, a register recall causes a recall of the
register, sets the Time Cursor at Time 0, and causes an
immediate run if the effect contains more than one
keyframe.
Misc
Chan 1
Chan 2
Camera
Global
Enable
All
Auto
Recall
Auto
Run