Filter
Top Products
2-18
Section 2— Control Panel Descriptions
You can use the lever arm in combination with the AUTO
TRANs
button to perform a transition. You can start the
transition by moving the lever arm off its limit, and finish the
transition by pressing AUTO TRANs. The transition is
completed at a rate proportional to the rate set for a full AUTO
TRANs
transition. For example, if the lever arm is moved
halfway and the transition is completed by pressing AUTO
TRANs
at a rate of 200 frames, the remaining half of the
transition will take 100 frames.
NOTE:
The lever arm will be left off-limit any time you begin a
transition with the lever arm and finish it with AUTO TRANs. The lever
arm
will not function properly again until is moved to either limit (this
action will not change the M/E output). While the lever arm is non-
functional, both lever arm direction indicators are on.