Filter
Top Products
2-43
Effects Memory Subpanel
Initiate sequences by pressing the following buttons:
SEQ, register
The sequence starts at the register indicated, and proceeds
through the linked sequence to the last register. If a loop has been
programmed, the sequence loop continues until the SEQ button is
pressed to terminate the sequence.
A sequence loop can be broken by double-pressing a register
button, clearing the sequence link that existed in that register, and
making the invoked register the last register in the sequence.
During a sequence of registers with multiple levels, the SEQ
button will high tally if any of the enabled levels was learned with
a sequence. However, it may be that not all enabled levels are
sequencing.
Different sequence delays may be learned separately into
different enabled levels. Sequence delays on different levels are
completely independent, and thus the sequencing may be
occurring at different times on different levels.
If an E-MEM level is disabled while it is actively sequencing, the
sequence will continue. Turning off the
SEQ button will not halt
the sequence, because the sequencing level is not delegated. To
ensure halting all actively running sequences, all E-MEM levels
must be enabled (ENABLe ALL) and then SEQ turned off.
EFFect DIS causes an S-linear transition from the current state to
the next recalled register. The current state may be a setup you
have just done on the control panel or the state resulting from a
register recall.
An effects dissolve may be learned into a register, so that recalling
that register will initiate a dissolve to another specified register.
The following button sequence is used to learn a dissolve
(parameters in angle brackets (<...>) are optional):
NOTE:
Only areas which are enabled will be learned. For more
information read Enable Buttons on page 2-47.
Effect
Dis