Filter
Top Products
2-41
Effects Memory Subpanel
The LOCK function locks a single register. Locking a register
prevents the contents of that register from being changed. To lock
the current register, press the following buttons:
↑, LOCK
When locked, an “L” is displayed at the left end of the
E-MEM readout, next to the register number. To unlock the
register, press the buttons again:
↑, LOCK
NOTE:
You cannot lock an entire E-MEM bank from the subpanel; a
menu selection is provided for this action. See E-MEM Register Menu
on page 3-83
Pressing the BANK 0 button makes Bank 0 the current bank, and
causes buttons 0 through 9 on the keypad to become one-button
recall registers for registers 00 through 09. This button is lit
whenever Bank 0 is the current bank.
Pressing
BANK 1 makes Bank 1 the current bank, and causes
buttons 0 through 9 on the keypad to become one-button recall
registers for registers 10 through 19. This button is lit whenever
Bank 1 is the current bank.
ENTER confirms a numerical entry on the keypad, such as for the
following functions: GET, PUT, and TRAN RATE. The ENTER
button lights when pressed.
Bank
Lock
Learn
Bank 0
Bank 1
Trim
Enter