Filter
Top Products
3-34
Section 3 — Menu Descriptions
3. Set the CONTROL DELAY to 6 fields
4. PORT ASSIGN is set automatically to PORT A1. The baud rate
for Port A1 is fixed at 307 Kbaud.
5. Set CHANNEL ROUTING for BOTH or SWR IN, depending upon
your system configuration, as described in “DPM
Configurations” in the Model 2200 User Guide.
6. Press the CPU Reset button through the hole in the door of the
switcher frame.
Communication should now be established between the Model
2200 and Krystal.
For Krystal:
1. Set the DPM TYPE to KRYSTAL. The values denoted in Steps
2 through 4 are set automatically.
2. Turn the EFF SEND DELAY soft knob to select 5 fields. It is
important to set this delay correctly.
3. Turn the CONTROL DELAY soft knob to select 6 fields.
4. PORT ASSIGN is set automatically to PORT A1. The baud rate
for Port A1 is fixed at 307 K baud.
5. Set CHANNEL ROUTING for BOTH or SWR IN, depending upon
your system configuration, as described previously under
“DPM Configurations.”
6. Reset the Control Processor in the Model 2200 Signal
Processor frame. This is done by opening the front door of the
Processor and pressing the RESET button located near the
top of the Control Processor module.
Communication should now be established between the Model
2200 and Krystal.