Filter
Top Products
RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator’s Guide
Polycom®, Inc. 789
Manually Adding Flags to the CS_MODULE_PARAMETERS Tab
Using the procedure to manually add flags to the System Configuration, the following flags can be manually
added to the CS_MODULE_PARAMETERS
tab:
VSW_RATE_TOLERANCE_PER
ECENT
Determines the percentage of bandwidth that can be deducted from
the required bandwidth to allow participants to connect to the
conference.
For example, a value of 20 will allow a participant to connect to the
conference if the allocated line rate is up to 20% lower than the
conference line rate (or between 80% to 100% of the required
bandwidth).
Range: 0 - 75
Default: 0
VSW_SD_HP_THRESHOLD_BIT
RATE
Controls the Minimum Threshold Line Rate (kbps) for SD resolution for
High Profile-enabled VSW conferences.
Default: 128
WRONG_NUMBER_DIAL_
RETRIES
The number of re-dial attempts for a wrong destination number or a
wrong destination number time-out.
Range: 0 - 5
Default: 3
A flag value of 0 means that no redials are attempted.
Manually Added CS_MODULE_PARAMETERS System Flags
Flag Description
CS_ENABLE_EPC Add this flag with the value YES (default value is NO) to enable endpoints that support
People+Content and require a different signaling (for example, FX endpoints) to receive
Content.
H245_TUNNELING For use in the Avaya Environment.
In the Avaya Environment, set the flag to YES to ensure that H.245 is tunneled through
H.225. Both H.245 and H.225 will use the same signaling port.
Default: NO.
H323_RAS_IPV6 If the Collaboration Server is configured for IPv4 & IPv6 addressing, RAS (Registration,
Admission, and Status) messages are sent in both IPv4 and IPv6 format. If the
gatekeeper cannot operate in IPv6 addressing mode, registration fails and endpoints
cannot connect using the Collaboration Server prefix.
In such cases this System Flag should be set to NO.
Default: YES
Manually Added, Modified, Deleted System Flags
Flag Description