Filter
Top Products
RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator’s Guide
Polycom®, Inc. 901
Tests Selection - Additional Test Parameters
8 The selected tests are initialized. In the Tests Monitoring pane there is an indication of the
Connection Status of the Tests.
9 This process may take some time. Click Stop Running Test to end all the diagnostic tests. The MCU
completes the current test running and then stops all remaining tests.
10 The Diagnostics Mode can be exited by pressing the yellow System Reset icon. The Collaboration
Server then resets.
Diagnostics Monitoring
A hardware component’s test status can be viewed in the Diagnostics Test Monitoring section before, during
and after tests have been initiated. Test results will only be displayed after tests are completed. The
Diagnostic Tests Monitoring section is comprised of three tabs: MCU Monitor, Cards Monitor and Error
Buffer, which are further described below.
Parameter Description
Loop Test Enter the amount of times the test is to repeat itself in succession.
Stop On Failure Stops tests upon a failure.
Run All Test Runs all tests listed in the TestActive column for the hardware component.
Connection Status