Filter
Top Products
10-7
User Guide for Cisco Secure Access Control System 5.3
OL-24201-01
Chapter 10 Managing Access Policies
Configuring the Service Selection Policy
To configure a rule-based service selection policy, see these topics:
• Creating, Duplicating, and Editing Service Selection Rules, page 10-8
• Deleting Service Selection Rules, page 10-10
After you configure your service selection policy, you can continue to configure your access service
policies. See Configuring Access Service Policies, page 10-21.
Table 10-2 Rule-based Service Selection Policy Page
Option Description
Policy type Defines the type of policy to configure:
• Select one result—Results apply to all requests.
• Rule-based result selection—Configuration rules apply different results depending on the
request.
Status Current status of the rule that drives service selection. The rule statuses are:
• Enabled—The rule is active.
• Disabled—ACS does not apply the results of the rule.
• Monitor Only—The rule is active, but ACS does not apply the results of the rule. Results such
as hit count are written to the log, and the log entry includes an identification that the rule is
monitor only. The monitor option is especially useful for watching the results of a new rule.
Name Rule name.
Conditions Conditions that determine the scope of the service. This column displays all current conditions in
subcolumns.
You cannot use identity-based conditions in a service selection rule.
Results Service that runs as a result of the evaluation of the rule.
Hit Count Number of times that the rule is matched. Click Hit Count to refresh and reset this column.
Default Rule ACS applies the Default rule when:
• Enabled rules are not matched.
• No other rules are defined.
Click the link to edit the Default Rule. You can edit only the results of the Default Rule; you
cannot delete, disable, or duplicate it.
Customize button Opens the Customize page in which you choose the types of conditions to use in policy rules. A
new Conditions column appears in the Policy page for each condition that you add.
Caution If you remove a condition type after defining rules, you will lose any conditions that
you configured for that condition type.
Hit Count button Opens a window that enables you to reset and refresh the Hit Count display in the Policy page.
See Displaying Hit Counts, page 10-10.