Filter
Top Products
Place Record Layout Detail
Mark: ᑍR1 Measurement method: Row/Column
Type choices, press Enter.
Position:
Across . . . . . . . . . . . 1 1-999
Down . . . . . . . . . . . . 4 1-999
Element . . . . . . . . . . . Name
Direction . . . . . . . . . . 1 1=Across, 2=Down
Repetition:
Across . . . . . . . . . . . 1 1-99
Down . . . . . . . . . . . . 1 1-99
Distance:
Across . . . . . . . . . . . 1-999
Down . . . . . . . . . . . . 1-999
| F3=Exit F5=Refresh F6=Change measurement method F12=Cancel
From this display, you can specify further detail characteristics of the record
element. For example, you can specify the direction, repetition, and distance.
The following table explains each field of the Place Record Layout Detail display.
Field Name Description
Mark Shows the element mark. A mark is either a system-assigned mark or
a user assigned-name, and is the same as that shown on the display.
| A mark is six characters long, the first character is an asterisk (*), and
| the last character is a blank.
For a system-assigned mark, the middle four characters are one
character for the element type followed by a three-digit sequence
number. For record layouts, the element type is R and the
sequence number is 001 to 999.
For a user-assigned name, the middle four characters are four
characters specified as the value for the element name.
| Note: When the record mark is displayed on the Design Page Layout
| screen, a dash and a three-digit repetition number are inserted after the
| fifth character of the record mark (for example, *R001-001 ).
Measurement
method
Shows the measurement method used to specify position. You can
change this value by pressing F6. You can also select centimeters or
inches for the measurement unit in the Define PFD Specifications
display by specifying unit of measure.
Position The record position is defined by the horizontal distance (across) and
the vertical distance (down) from the page origin.
Across Specifies the horizontal origin of the element in the specified
measurement method.
Down Specifies the vertical origin of the element in the specified measurement
method.
Element An element name is 1 to 4 characters in length. If an element name is
specified (not blank) for an element, the element mark is displayed as
an asterisk (*) followed by the element name. It is not an asterisk (*)
followed by the element type and three-digit sequence number.
Chapter 10. Work with PFD Definitions 169