IBM AS/400 Photo Scanner User Manual


 
See the description of the CRTPRTF command in the
CL Reference
for more
information about these parameters.
Change Font (Font Type=2):
When you choose 2 for the
Font type
prompt, the
following display appears.
Change PFD Definition Font
Font number . . . . . . . . : 1
Font type . . . . . . . . . : 2 Coded font
Type choices, press Enter.
Coded font . . . . . . . . . Name, F4 for list
| Point size . . . . . . . . . ᑍNONE .1-999.9, ᑍNONE
Text 'description' . . . . .
F3=Exit F4=Prompt F5=Refresh F12=Cancel
| Using this display you can change the coded font to use, point size for outline
| fonts, and description text.
The following table explains the Change Source Overlay Font display and the
Change PFD Definition Font display.
Field Name Description
Point size| Specifies the point size. You can use a value from 0.1 to 999.9 for
| your point size.
Graphic
character set
| Specifies the graphic character identifier. You can use a number from
1 to 32767. You can also specify *SYSVAL.
Code page| Specifies the code page. You can type a number from 1 to 32767 for
your code page.
Text Specifies the description for this font. This is just a remark and is
helpful to you when you select a font from the list.
Option Description
Font number Shows the font number of the font being changed.
Font type Shows the font type you specified in the previous display.
Coded font| Specifies a coded font name. To display a selection list of all coded
| fonts in library QFNTCPL and all libraries in your library list, press F4
| with the cursor in this field.
| Point size| Specifies the point size you want. You can use a value from 0.1 to
| 999.9 for the point size. 1 point is equal to 1/72 inch. Point size is only
| valid for outline fonts. The value will be ignored for raster fonts.
294 AFP Utilities for AS/400 User’s Guide