IBM AS/400 Photo Scanner User Manual


 
Place Record Layout Detail
Mark: ᑍR1 Measurement method: Row/Column
Type choices, press Enter.
Position:
Across . . . . . . . . . . . 5 1-999
Down . . . . . . . . . . . . 5 1-999
Element . . . . . . . . . . . Name
Direction . . . . . . . . . . 1 1=Across, 2=Down
Repetition:
Across . . . . . . . . . . . 1 1-99
Down . . . . . . . . . . . . 1 1-99
Distance:
Across . . . . . . . . . . . 1-999
Down . . . . . . . . . . . . 1-999
F3=Exit F4=Prompt F5=Refresh F6=Change measurement method F12=Cancel
From this display, you can specify further detail characteristics of the place record
element. For example, you can specify the direction, repetition, and distance.
Field Name Description
Mark Shows the element mark. A mark is either a system-assigned mark or
a user assigned-name, and is the same as that shown on the display.
A mark is six characters long and the first character is an asterisk (*)
and the last character is a blank. The middle four characters are:
For a system-assigned mark, the middle four characters are one
character for the element type followed by a three-digit sequence
number. For record elements, the element type is R and the
sequence number is 001 to 999.
For a user-assigned name, the middle four characters are four
characters specified as the value for the element name.
| Note: Because the record layout may be placed repeatedly, when it is
| placed on the page layout, each mark for record layouts is followed by
| a repetition number from 001 to 999.
Measurement
method
Shows the measurement method used to specify position. You can
change this value by pressing F6. You can also select centimeters or
inches for the measurement unit in the Define PFD Specifications
display by specifying unit of measure.
Position Specifies the horizontal and vertical positions of the record layout.
Element An element name is 1 to 4 characters in length. If an element name is
specified (not blank) for an element, the element mark is displayed as
an asterisk (*) followed by the element name.
Chapter 13. Design Operation 277