Filter
Top Products
Field Name Description
Text 'description' Specifies text that briefly describes the member and its function. The
description should be specified with no more than 50 characters of text
and enclosed in apostrophes.
The possible values are:
*OVLTXT
Specifies the same description of the overlay shown in the
Overlay
field is used.
'description'
Specify the description of the member.
Replace Specifies whether or not the physical file member replaces the existing
physical file member if a physical file member of the same name
already exists in the library.
The possible values are:
N
A new physical file member is not created if an old physical file
member of the same name already exists in the library.
Y A new physical file member is created and the old physical file
member is replaced by it.
Create file Specifies whether or not the file is created if the file does not exist.
The possible values are:
N
Do not create the file.
Y Create the file.
Text 'description' Specify text that briefly describes the file and its function. This prompt
is valid only when Y is specified in the
Create file
prompt. The
description should be specified with no more than 50 characters of text
and enclosed in apostrophes.
13=Change Overlay Text
To change an overlay text, do the following on the Work with Overlays display on
page 333.
1. Type 13 in the
Opt
column beside the overlay for which you want to change the
description text.
2. Press Enter.
The CL command CHGOBJD is called.
Chapter 19. Work with Overlays Function 341