Filter
Top Products
length-value
Specify the length value in the selected unit of measure.
| Mapping option (MAPPING)
Specifies how the input image is mapped to the specified size of the
output image in the page segment.
The possible values are:
*SAME
Specifies the mapping option used when you previously created a
page segment of the same name.
*PAT (Position and trim)
The top left corner of the input image is located to the top left corner
of the output image area. The image size is not changed, and any
portion of the input image that falls outside of the output image size
is trimmed.
*STF (Scale to fit)
The center of the input image is located to the center of the output
image area. The image size is changed so that the input image fits
in the output image size.
*CAT (Center and trim)
The center of the input image is located to the center of the output
image area. The image size is not changed, and any portion of the
input image that falls outside of the output image size is trimmed.
*IPTP (Image point to pel)
The top left corner of the input image is located to the top left corner
of the output image area. No resolution correction is done and each
image point in the input image is mapped to a pel of the output
printer. The image size may vary depending on the pel-density of
the output printer, and any portion of the input image that falls
outside of the output image size is trimmed.
*IPTPD (Image point to pel with double dot)
The top left corner of the input image is located to the top left corner
of the output image area. No resolution correction is done and each
image point in the input image is doubled (replicated) in both
dimensions and mapped to pels of the output printer. The image
size may vary depending on the pel-density of the output printer,
and any portion of the input image that falls outside of the output
image size is trimmed.
Degree of rotation (IMGRTT)
Specifies the degree of the clockwise rotation of the output image. The
center of the rotation is the top left corner of the image.
The possible values are:
*SAME
Specifies the degree of rotation used when you previously created a
page segment of the same name.
0 No rotation is done.
376 AFP Utilities for AS/400 User’s Guide