Filter
Top Products
member-name
Specify the member name that is to be converted.
Change image size (CHGIMGSIZE)
Specifies whether the size of the image in the page segment is changed
or not.
The possible values are:
*SAME
Specifies the same value used for this parameter when you
previously created a page segment of the same name. If this is the
first page segment, the default value is *NO.
*NO
Specifies not to change the image size.
*YES
Specifies to change the image size.
| If you specify *YES, the IMGSIZE and MAPPING parameters will
| appear, and you can specify the new image size in the page
segment and how to map the input image to the size.
Image area size (IMGSIZE)
Specifies the unit of measurement, width, and length of the image to be
created in the page segment.
Unit of measure
Specifies the unit of measure used to specify the following
two parameters.
The possible values are:
*SAME
Specifies the unit of measure used when you previously
created a page segment of the same name.
*INCH
Inch is used as the unit of measure.
*CM
Centimeter is used as the unit of measure.
Width Specifies the width of the image to be created.
The possible values are:
*SAME
Specifies the value of the width used when you
previously created a page segment of the same name.
width-value
Specify the width value in the selected unit of measure.
Length Specifies the length of the image to be created.
The possible values are:
*SAME
Specifies the value of the length used when you
previously created a page segment of the same name.
Chapter 21. AFP Utilities for AS/400 Commands 375