Filter
Top Products
Press Enter, the F3, or F12 key after you specify the parameters, or press the F4
key to specify more parameters.
When you press the F4 key, the following display appears. You can specify further
details of the box element. For example, you can specify the line type, the line
width, the line placement, the shading pattern, and the shading type on this display.
Define Box Detail
Mark: ᑍB2 Measurement method: Row/Column
Type choices, press Enter.
Start position:
Across . . . . . . . . . . 5 1-999
Down . . . . . . . . . . . 4 1-999
End position:
Across . . . . . . . . . . 6 1-999
Down . . . . . . . . . . . 1 1-999
Element . . . . . . . . . . Name
Line type . . . . . . . . . 1 1=Solid, 2=Dashed, 3=Dotted
Line width . . . . . . . . . ᑍMEDIUM ᑍNARROW, ᑍMEDIUM, ᑍWIDE
.-1.
Line placement . . . . . . . 1 1=Middle, 2=Border
More...
F3=Exit F4=Prompt F5=Refresh F6=Change measurement method F12=Cancel
Press the Roll Up (Page Down) key to see the next page of the Define Box Detail
display.
Field Name Description
Measurement
method
This field shows the measurement method used to specify the position.
You may change this field by pressing the F6 key.
Start position The position parameter consists of across and down values. These
values specify the horizontal and vertical start position of the element
being defined.
End position The position parameter consists of across and down values. These
values specify the horizontal and vertical end position of the element
being defined.
Chapter 13. Design Operation 245