Filter
Top Products
Teledyne API - T100 UV Fluorescence SO2 Analyzer Communications Setup and Operation
139
6.5.1. CONFIGURING ETHERNET COMMUNICATION MANUALLY (STATIC
IP ADDRESS)
1. Connect a cable from the analyzer’s Ethernet port to a Local Area Network (LAN) or
Internet port.
2. From the analyzer’s front panel touchscreen, access the Communications Menu
(SETUP>MORE>COMM as shown in Figure 5-13.
3.
Follow the
setup sequence as shown in Figure 6-4, and edit the Instrument and
Gateway IP addres
ses and Subnet Mask to the desired settings.
4. From the computer, enter the same information through an application such as
HyperTerminal.
Table 6-3 shows the default Ethernet configuration settings.
Table 6-3: LAN/Internet Default Configuration Properties
PROPERTY DEFAULT STATE DESCRIPTION
DHCP
ON
This displays whether the DHCP is turned ON or OFF. Press
EDIT and toggle ON for automatic configuration after first
consulting network administrator. (
INSTRUMENT IP
ADDRESS
This string of four packets of 1 to 3 numbers each (e.g.
192.168.76.55.) is the address of the analyzer itself.
GATEWAY IP
ADDRESS
0.0.0.0
Can only be edited when DHCP is set to OFF.
A string of numbers very similar to the Instrument IP address
(e.g. 192.168.76.1.) that is the address of the computer used
by your LAN to access the Internet.
SUBNET MASK
0.0.0.0
Can only be edited when DHCP is set to OFF.
Also a string of four packets of 1 to 3 numbers each (e.g.
255.255.252.0) that identifies the LAN to which the device is
connected.
All addressable devices and computers on a LAN must have
the same subnet mask. Any transmissions sent to devices
with different subnets are assumed to be outside of the LAN
and are routed through the gateway computer onto the
Internet.
TCP PORT
1
3000
This number defines the terminal control port by which the
instrument is addressed by terminal emulation software, such
as Internet or Teledyne API’s APICOM.
HOST NAME
T100
The name by which your analyzer will appear when
addressed from other computers on the LAN or via the
Internet. To change, see Section 6.5.2.1.
1
Do not change the setting for this property unless instructed to by Teledyne API’s Technical Support
personnel.
06807C DCN6650