Filter
Top Products
Teledyne API - Models T100, 100E Series (05036F DCN6650) APPENDIX A - Version Specific Software Documentation
Rev 1.0.3 (T-Series)/G6 (E-Series)
05036 Rev D A-13
SETUP VARIABLE
NUMERIC
UNITS
DEFAULT
VALUE
VALUE RANGE DESCRIPTION
O2_FILT_ADAPT
10
— ON ON, OFF
ON enables O
2
adaptive filter; OFF
disables it.
O2_FILT_SIZE
10
Samples 60 1–500
O
2
moving average filter size in normal
mode.
O2_FILT_ASIZE
10
Samples 10 1–500
O
2
moving average filter size in
adaptive mode.
O2_FILT_DELTA
10
% 2 0.1–100
Absolute change in O
2
concentration to
shorten filter.
O2_FILT_PCT
10
% 2 0.1–100
Relative change in O
2
concentration to
shorten filter.
O2_FILT_DELAY
10
Seconds 20 0–300
Delay before leaving O
2
adaptive filter
mode.
O2_DIL_FACTOR
10
— 1 0.1–1000
Dilution factor for O
2
. Used only if is
dilution enabled with FACTORY_OPT
variable.
50 O2_CELL_SET
10
ºC
Warnings:
45–55
30–70
O
2
sensor cell temperature set point
and warning limits.
O2_STD_CELL_TEMP
10
ºK 323 1–500
Standard O
2
cell temperature for
temperature compensation.
O2_STD_CELL_PRESS
10
"Hg 28.50 1.00–50.00
Standard O
2
cell pressure for pressure
compensation.
USER_UNITS — PPB,
PPM
3
PPB,
PPM,
UGM,
MGM,
PPM
3
,
MGM
3
Concentration units for user interface.
Enclose value in double quotes (“)
when setting from the RS-232
interface.
LAMP_DRIVE
6
mV 5000 0–5000 Lamp power setting.
LAMP_CAL mV 3500 1000–5000 Last calibrated UV lamp reading.
LAMP_GAIN — 0.95 0.5–1.5
UV lamp compensation attenuation
factor.
BXTEMP_TPC_GAIN — 1,
0
12
0–10
Box temperature compensation
attenuation factor.
SPRESS_TPC_GAIN — 1 0–10
Sample pressure compensation
attenuation factor.
PMT_TARG_CONC
12
Conc 400 0.01–9999.99
Target SO
2
concentration during PMT
calibration.
PMT_UPDATE_PERIOD
12
Seconds 10 1–100
Period between HVPS gain updates
during PMT calibration.
PMT_CAL_TIMEOUT
12
Minutes 30 1–100
Maximum time for PMT calibration to
succeed.
HVPS_ADJUST
12
— 0 0–200 HVPS gain adjustment.
HVPS_INTEG
12
Gain 5 0–500
Integral coefficient for adjusting HVPS
gain during PMT calibration.
HVPS_STABIL
12
— 1 0.1–10
HVPS gain must stabilize to within this
limit for PMT calibration to succeed.
PMT_ADJUST
12
— 0 0–65535 PMT gain adjustment.
06807C DCN6650