Filter
Top Products
Teledyne API - T100 UV Fluorescence SO2 Analyzer Introduction, Features and Options
27
OPTION
OPTION
NUMBER
DESCRIPTION/NOTES REFERENCE
Second Gas Sensors Choice of one additional gas sensor.
65A Oxygen (O
2
) Sensor
• Section 2.1 (specs
)
• Section 3.3.2.8,
(pneumatic layout)
• Section 9.10.1
(calibra
tion)
• Section 13.2 for
princi
pl
es of
operation
67A Carbon Dioxide (CO
2
) Sensor
• Section 2.1 (specs
)
• Section 3.3.2.9
(pneumatic layout)
• Section 9.10.2
(calibration)
• Section 13.3
(principles of
operation)
Special Features Built in features, software activated
N/A
Maintenance Mode Switch, located inside the instrument, places the
analyzer in maintenance mode where it can continue sampling, yet
ignore calibration, diagnostic, and reset instrument commands. This
feature is of particular use for instruments connected to Multidrop or
Hessen protocol networks.
Call Technical Support for activation.
N/A
N/A
Second Language Switch activates an alternate set of display
messages in a language other than the instrument’s default language.
Call Technical Support for a specially programmed Disk on Module containing
the second language.
N/A
N/A
Dilution Ratio Option allows the user to compensate for diluted
sample gas, such as in continuous emission monitoring (CEM) where
the quality of gas in a smoke stack is being tested and the sampling
method used to remove the gas from the stack dilutes the gas.
Call Technical Support for activation.
Section 3.4.4.1,
5.4.5 and 13.1.9.3
06807C DCN6650