Filter
Top Products
Communications Setup and Operation Teledyne API - T100 UV Fluorescence SO2 Analyzer
148
6.6.2.2. ACTIVATING HESSEN PROTOCOL
The first step in configuring the T100 to operate over a Hessen protocol network is to
activate the Hessen mode for COMM ports and configure the communication
parameters for the port(s) appropriately. Access the COMMUNICATIONS Menu (refer
to Figure 5-13), then press:
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X COM1 MODE: 0
SET> EDIT EXIT
Continue pressing next until …
Select which COMM
port to configure
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL: ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL: OFF
PREV NEXT OFF ENTR EXIT
ENTR accepts the new
settings
EXIT ignores the new
settin
g
s
The sum of the mode
IDs of the selected
modes is displayed
here
SETUP X.X COM1 E,7,1 MODE: ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
Press OFF/ON to
change
activate/deactivate
selected mode.
Repeat the
entire process to
set up the
COM2 port
SETUP X.X COM1 E,8,1 MODE: ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 E,8,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
Figure 6-7: COMM – Activating Hessen Protocol
06807C DCN6650