Filter
Top Products
Teledyne API - T100 UV Fluorescence SO2 Analyzer Overview of Operating Modes
87
4.3.2. PRIMARY SETUP MENU
Table 4-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
CONTROL
BUTTON
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration
CFG
Lists key hardware and software configuration information. 5.1
Auto Cal Feature
ACAL
Used to set up and operate the AutoCal feature.
Only appears if the analyzer has one of the internal valve
options installed.
5.2 & 9.8
Internal Data Acquisition
(DAS)
DAS
Used to set up the DAS system and view recorded data. 5.3 & 0
Analog Output Reporting
Range Configuration
RNGE
Used to configure the output signals generated by the
instrument’s Analog outputs.
5.4
Calibration Password Security
PASS
Turns the calibration password protection feature ON/OFF. 5.5
Internal Clock Configuration
CLK
Used to Set or adjust the instrument’s internal clock. 5.6
Advanced SETUP features MORE
This button accesses the instruments secondary setup menu.
See
Table 4-5
4.3.3. SECONDARY SETUP MENU (SETUP>MORE)
Table 4-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
MENU
ITEM
DESCRIPTION
MANUAL
SECTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various external I/O
channels including RS-232; RS 485, modem communication
and/or Ethernet access.
5.7 & 6
System Status Variables
VARS
Used to view various variables related to the instrument’s current
operational status
5.8
System Diagnostic Features
DIAG
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer’s basic
systems
5.9
IMPORTANT
IMPACT ON READINGS OR DATA
Any changes made to a variable during the SETUP procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the
EXIT button is pressed before the ENTR button, the analyzer will beep,
alerting the user that the newly entered value has not been accepted.
06807C DCN6650