Filter
Top Products
Getting Started Teledyne API - T100 UV Fluorescence SO2 Analyzer
52
USB CONNECTION
For direct communication between the analyzer and a PC, connect a USB cable between
the analyzer and desktop or laptop USB ports, and ensure that their baud rates match
(Section 6.2.2).
Note If this option is installe
d, the COM2 port cannot be used for anything
other than Multidrop communication.
Configuration: Section 6.5.3
RS-232 CONNECTION
For RS-232 communications with data terminal equipment (DTE) or with data
communication equipment (DCE) connect either a DB9-female-to-DB9-female cable
(Teledyne API part number WR000077) or a DB9-female-to-DB25-male cable (Option
60A, Section 1.4), as applicable, from the analyzer’s rear panel RS-232 port to the
device. Adjust the DCE-DTE switch (Figure 3-4) t
o select DTE or DCE as appropriate.
Configuration: Sections 5.7 and 6.3
IMPORTANT
IMPACT ON READINGS OR DATA
Cables that appear to be compatible because of matching connectors
may incorporate internal wiring that makes the link inoperable. Check
cables acquired from sources other than Teledyne API for pin
assignments (Figure 3-12) before using.
06807C DCN6650