Open as PDF
You can set how long the image is displayed on the LCD monitor just
after shooting. If [Off] is set, the image will not be displayed just after
shooting. If [Hold] is set, the image review will be displayed up until the
[Auto power off] time has elapsed.
During image review, if you operate any camera controls such as
pressing the shutter button halfway, the image review will end.
Under the [z1] tab, select [Image
review], then press <0>. Select the
desired setting, then press <0>.
To save battery power, the camera turns off automatically after the set
time of idle operation elapses. You can set this auto power-off time.
When the camera is turned off due to auto power off, you can turn it on
again by pressing the shutter button, etc.
If [Disable] is set, either turn off the camera or press the <B>
button to turn off the LCD monitor to save battery power.
Even when [Disable] is set, if the camera is not used for 30 min.,
the LCD monitor will turn off automatically. To turn on the LCD
monitor again, press the <B> button.
Under the  tab, select [Auto power
off], then press <0>. Select the desired
setting, then press <0>.
3 Setting the Image Review Time
3 Setting the Auto Power-off Time