Filter
Top Products
389
Troubleshooting Guide
Depending on the lens type, shutter speed, aperture, subject
conditions, brightness, etc., the continuous shooting speed may
become slower.
If [z3: Anti-flicker shoot.] is set to [Enable] and you shoot under a
flickering light source, the continuous shooting speed may become
slightly slower, or the continuous shooting interval may become
irregular. Also, the time lag until shutter release may be slightly longer
than usual (p.154).
If you set [Distortion] to [Enable], the continuous shooting speed will
decrease (p.151).
If you shoot something that has fine detail such as a field of grass, the
file size will be larger, and the actual maximum burst may be lower
than the number mentioned on page 127.
Under [54: Custom Functions (C.Fn)], if [3: Highlight tone priority]
is set to [1: Enable], ISO 100 cannot be set. If [0: Disable] is set, ISO
100 can be set (p.353). This also applies to movie shooting (p.238).
Under [
5
4: Custom Functions (C.Fn)
], if [
3: Highlight tone priority
] is
set to [
1: Enable
], the [
H
] ISO speed (equivalent to ISO 25600) cannot
be selected even when [
2: ISO expansion
] is set to [
1: On
]. If [
0:
Disable
] is set for [
3: Highlight tone priority
], [
H
] can be set (p.353).
Under [54: Custom Functions (C.Fn)], if [3: Highlight tone priority]
is set to [1: Enable], the Auto Lighting Optimizer cannot be set. If [0:
Disable] is set, the Auto Lighting Optimizer can be set (p.353).
The continuous shooting speed is slow.
The maximum burst during continuous shooting is lower.
ISO 100 cannot be set.
ISO speed [H] (equivalent to ISO 25600) cannot be set.
The Auto Lighting Optimizer cannot be set.