Filter
Top Products
385
If a problem occurs with the camera, first consult this Troubleshooting
Guide. If this Troubleshooting Guide does not resolve the problem,
contact your dealer or nearest Canon Service Center.
Do not use any battery pack other than a genuine Battery Pack
LP-E17.
If (1) the battery charger or battery pack has a problem or (2)
communication with the battery pack failed (with a non-Canon battery
pack), the protection circuit will stop charging, and the charge lamp will
blink in orange. In the case of (1), unplug the charger’s power plug
from the power outlet. Detach and reattach the battery pack to the
charger. Wait a few minutes, then reconnect the power plug to the
power outlet. If the problem persists, contact your dealer or nearest
Canon Service Center.
Make sure the battery is properly installed in the camera (p.38).
Make sure the battery compartment cover is closed (p.38).
Make sure the card slot cover is closed (p.39).
Recharge the battery (p.36).
Press the <B> button (p.67).
If the power is turned off while an image is being recorded to the card,
the access lamp will remain on/continue to blink for a few seconds.
When the image recording is completed, the power will turn off
automatically.
Troubleshooting Guide
Power-Related Problems
The battery pack does not recharge.
The battery charger’s lamp blinks.
The camera does not operate even when the power switch is set to <
1
>.
The access lamp still blinks even when the power switch is set to <
2
>.