Open as PDF
Preparing to Print
Play back the image.
Press the <x> button.
The image will appear with the <w>
icon on the upper left of the screen to
indicate that the camera is connected
to a printer.
Before using the printer, make sure it has a PictBridge connection port.
Movies cannot be printed.
The camera cannot be used with printers compatible only with CP Direct
or Bubble Jet Direct.
Do not use any interface cable other than the one provided.
If there is a long beeping sound in step 5, it indicates a problem with the
printer. Resolve the problem displayed in the error message (p.342).
If any of the following shooting modes or functions is set, the camera
cannot be connected to a printer. Cancel all the relevant settings, then
reconnect the camera to the printer with an interface cable.
•<F> or <G> in <8> mode
• Multi Shot Noise Reduction
•[51: Wi-Fi/NFC] set to [Enable]
You can also print RAW images taken with this camera.
When you use a battery to power the camera, make sure it is fully
charged. With a fully-charged battery pack, you can print for approx. 2 hr.
Before disconnecting the cable, first turn off the camera and printer. Hold
the plug (not the cord) to pull out the cable.
For direct printing, using AC Adapter Kit ACK-E18 (sold separately) to
power the camera is recommended.