Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install Management Terminal and Activate System
Page 3-4Install Management Terminal
3
Figure 3-2. Rear Panels on Management Terminals
Connect to the System
1. Route the 25-pin DTE cable from the terminal to the rear of the system.
2. For Release 6si, connect the cable to the TERM connector. See Figure
3-3. For Release 6r, connect the cable to the Terminal Active connector.
See Figure 3-4
.
3. Plug the AC power cord into the AC receptacle on the terminal. Plug the
opposite end of the power cord to the AC receptacle located at the bottom
rear of the cabinet, or into the selected AC receptacle.
4. Set the terminal power switch ON.
Figure Notes
1. Rear Panel of 715 BCS Terminal
2. 6-Pin Mini DIN Connector
3. Rear Panel of 2900/715 BCS Terminal
4. P2-DTE Port
5. Modular Keyboard Jack
6. COM 1 Port
7. Rear Panel of 715 BCS-2
Te r m i n a l
1
PAR
COM2
PARALL EL
COM1
P1-DCE
AUX PORT
P1-DCE
P2-DTE
MAINPORT
P2-DTE
21
0069_0RBP 072296