Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install Management Terminal and Activate System
Page 3-17Circuit Pack Administration
3
Circuit Pack Administration
After the equipment is installed (including circuit packs), the circuit packs must
be administered. Refer to
DEFINITY Enterprise Communications Server Release
6 Administration and Feature Description
for more information.
The following information describes general administration information:
■ Use the Circuit Packs form to administer circuit packs to carrier slots. The
circuit packs must be installed (or assigned using the Circuit Packs form)
before administering voice terminals, attendant consoles, or trunks.
■ Each page of the form represents 1 carrier in the cabinet shown on the
command line. For Release 6si, all carriers and slots appear even if they
are not included in the hardware.
■ It is not necessary to fill in the Circuit Packs form if the circuit packs are
installed at the time of administration.
■ Refer to
DEFINITY Communications System Generic 3 Planning and
Configuration
, 555-230-601, for more information about circuit pack
administration and port assignment records.
■ For initial installation, assign circuit packs to slots using the hardware
configuration layout record from the factory or Customer Services
Organization. Do not arbitrarily assign circuit packs to slots.
■ For Release 6r, if the carrier type administered on the Cabinet
Administration form does not match the physical hardware, question
marks (??) may display in the Code fields.
■ When a circuit pack in a slot differs from what has been administered on
the form, a “#” displays between the “Sfx” and “Name” fields.
■ For Release 6r, the number of slot fields displayed represents
administrable slots for the given carrier type. For Release 6si
configurations, all slot fields are displayed.