Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install Management Terminal and Activate System
Page 3-21Administer System Configurations (Release 6r)
3
Change Site-Data
This form initializes the building, floor, and color data to make them available
later in help messages that refer to site information.
1. At the Command: prompt, enter the change site-data command.
The first of 3 pages of site data appears:
2. Enter optional names for the buildings or offices served by the system.
3. Access the remaining site-data pages and fill them in appropriately.
Change Cabinet 1
1. Enter change cabinet 1. A screen similar to Screen 3-7 appears.
2. Fill in the blanks as required by the location and nature of the cabinet. If
the system is critical reliability, verify the B field is set to the processor
option, the D field is set to the dup-sw-node option, and the E field is set to
the switch-node option.
Screen 3-7. Typical Change Cabinet 1 Form