Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install and Wire Telephones and Other Equipment
Page 5-107Add Multiple Announcement
5
the number of the slot in which the circuit pack resides (01 to 21). When
executing a restore command and there are existing announcements on the
circuit pack, the following warning message appears:
WARNING: This restore announcement command will overwrite
the existing announcements on the specified
board.
After 5 minutes (with no alterations to the announcements), the TN750C
automatically copies the announcements from the Voice RAM to the internal flash
memory. The yellow LED on the front of the TN750C flashes.
You can only save the announcement contents of 1 circuit pack to mass storage
at a time. For the contents of every circuit pack, save to separate translation
cards. Label each card to match the circuit pack saved to it.
TN750 and TN750B Announcement Circuit Packs
NOTE:
The following save and restore procedures are only necessary for TN750
and TN750B announcement circuit packs.
The recorded announcements in the system can be saved on the mass-storage
system by entering the save announcements spe-active/spe-standby
command. These commands should only be used after business hours or when
the system is operating during a low-usage period. The system takes about 40
minutes to transfer the recorded announcements from the announcement circuit
pack to the mass-storage system. During this time period, the management
terminal cannot be used to administer the system until the transfer finishes;
however, all other administration terminals, if provided, are allowed to perform
administration procedures.
The recorded announcements in the system can be restored to system memory
from the translation card by entering the restore announcements command.