Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install and Wire Telephones and Other Equipment
Page 5-108Add Multiple Announcement
5
Replace a TN750B with a TN750C or Move all
Announcements from a TN750B to a TN750C
Use this procedure to replace a TN750B circuit pack with a TN750C circuit pack
or to move every announcement from a TN750B to a TN750C.
NOTE:
Do not copy or restore announcements from a TN750C to a TN750 or
TN750B circuit pack, as this may corrupt the announcement data.
1. Save announcements from the TN750/B to the mass-storage system.
2. Insert the TN750C circuit pack into a vacant slot of a carrier.
NOTE:
Any carrier is acceptable since power holdover is not a concern.
3. Lift the locking lever upward until the latch pin engages.
4. Administer a new data module on the TN750C circuit pack, as described
in
DEFINITY Enterprise Communications Server Release 6 Administration
and Feature Description
.
5. Execute the restore announcements command to the TN750C circuit
pack equipment location.
6. Wait until announcements copy from voice RAM to flash memory (yellow
LED on the TN750C stops flashing). This may take about 10 minutes.
7. Execute the busyout board 01c11 command for the TN750/B circuit
pack, where “01c11” is an example circuit pack location.
8. Execute the change integrated announcements command. This
modifies the translations for the TN750B circuit pack to reference the
TN750C circuit pack.
9. Verify proper playback of the announcements from the TN750C circuit
pack by calling them.
10. Execute the release board 01c11 command for the TN750/B circuit pack,
where “01c11” is an example circuit pack location.