Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install and Wire Telephones and Other Equipment
Page 5-109Add Multiple Announcement
5
Add Additional TN750C Circuit Packs
1. Install the TN750C into a vacant slot in a carrier.
NOTE:
Any carrier is acceptable since power holdover is not a concern.
2. Administer a new data module on the TN750C circuit pack, as described
in
DEFINITY Enterprise Communications Server Release 6 Administration
and Feature Description
.
3. Administer new announcements to that TN750C slot by executing the
change announcements command and filling in the “designated board
location” field for the circuit pack’s location.
4. Record the announcements, as described in
DEFINITY Enterprise
Communications Server Release 6 Administration and Feature
Description
.
5. Wait until the announcements copy from voice RAM to the on-board flash
memory (the yellow LED on the TN750C starts and then stops flashing).
This may take about 10 minutes.
Move a Single Announcement from 1
Announcement Circuit Pack to Another
1. Execute the change announcements command to change the circuit
pack locations of a particular announcement. You may also change the
compression rate at this time.
2. Rerecord the announcement, as described in
DEFINITY Enterprise
Communications Server Release 6 Administration and Feature
Description
.