Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Install and Wire Telephones and Other Equipment
Page 5-79Add the Fiber Optic Cable
5
4. Pull the tool (with adapter and cable attached) out through the front of the
cabinet. See Figure 5-35
.
5. From the rear, route the fiber optic cable through the opening vacated by
the I/O cable connector.
6. If necessary, remove the fiber adapter from the tool and plug the fiber
optic cable into the SC-SC (single-mode) or ST-SC (multimode) adapter.
See Figure 5-36
. Check the house cabling before selecting a coupling to
use.
7. From the front of the I/O connector adapter bracket (with fiber cable),
snap the coupling into the supplied I/O connector adapter bracket.
8. Snap the I/O connector adapter bracket into the I/O connector opening.
9. Attach the outside fiber plant to the I/O connector on the rear of the
cabinet.
Figure 5-35. Fiber Optic Cable and Adapter
lcda6fop RPY 021698