Filter
Top Products
DEFINITY Enterprise Communications Server Release 6
Installation and Test for Multi-Carrier Cabinets
555-230-112
Issue 5
May 1998
Option Switch Settings
Page B-8Call Detail Recording Option Settings
B
Call Detail Recording Option Settings
The interface between the system and CDR equipment may be 1 of the following:
■ Data Module — recommended option settings are shown in Tab le B-3.
■ Modem — recommended option settings are in modem vendor document
■ TN726 Data Line circuit pack and an Asynchronous Data Unit — data
modules or modems are not required.
■ Connected directly to the DCE connector (EIA Port) located on the rear of
the Control Carrier
— data modules or modems are not required.
A 572 Printer can be used as an output receiving device for CDR. The
recommended option settings for this printer is shown in Ta b le B -4
. Also, a
TELESEER, CDR, 94A Local Storage Unit (LSU), or Customer Premises
Equipment (CPE) can be used as the output receiving device.
Administration procedures for CDR equipment are provided in
DEFINITY
Enterprise Communications Server Release 6 Administration and Feature
Description
.
Table B-4. 572 Printer Used with Management Terminal, CDR,
or Journal Printer
Function Function Name Menu Menu Status
01 FORM LENGTH 09 11
02 LPI 01 6
03 CPI 01 10
04 LQ or NLQ 01 LQ
05 BUZZER 01 ON
06 FONT 02 FONTCART
07 RESOLUTION 01 144
11 BUFFER 02 N-LINE
13 PW ON MODE 01 ON-LINE
14 DIRECTION 01 B1-DIR.1
15 BUFF FULL 02 LF + CR
16 P.E. 01 ACTIVE
17 AUTO CARRIAGE RETURN (CR) 01 CR + LF
18 ZERO 01 0
22 AUTO LINE FEED 01 CR ONLY
Continued on next page