Filter
Top Products
Epson Research and Development Page 141
Vancouver Design Center
Hardware Functional Specification S1D13708
Issue Date: 02/03/07 X39A-A-001-02
bits 9-0 PIP
+
Window X End Position Bits [9:0]
These bits determine the X end position of the PIP
+
window in relation to the origin of the
panel. Due to the S1D13708 SwivelView feature, the X end position may not be a
horizontal position value (only true in 0° and 180° SwivelView). For further information
on defining the value of the X End Position register, see Section 13, “Picture-in-Picture
Plus (PIP+)” on page 184.
The register is also incremented differently based on the SwivelView orientation. For 0°
and 180° SwivelView the X end position is incremented by x pixels where x is relative to
the current color depth.
For 90° and 270° SwivelView the X end position is incremented in 1 line increments.
Depending on the color depth, some of the higher bits in this register are unused because
the maximum horizontal display width is 1024 pixels.
Note
These bits have no effect unless the Picture-in-Picture Plus PIP
+
Window Enable bit is
set to 1 (REG[71h] bit 4).
Note
The effect of REG[84h] through REG[91h] takes place only after REG[91h] is written
and at the next vertical non-display period.
PIP
+
Window X End Position Register 0
REG[8Ch] Read/Write
PIP
+
Window X End Position Bits 7-0
76543210
PIP
+
Window X End Position Register 1
REG[8Dh] Read/Write
n/a
PIP
+
Window X End Position
Bits 9-8
7 6 5 4 3 210
Table 8-13: 32-bit Address Increments for Color Depth
Color Depth Pixel Increment (x)
1 bpp 32
2 bpp 16
4 bpp 8
8 bpp 4
16 bpp 2