Filter
Top Products
Page 8 Epson Research and Development
Vancouver Design Center
S1D13708 Windows® CE 3.x Display Drivers
X39A-E-006-01 Issue Date: 01/11/14
Installation for CEPC Environment
Once the nk.bin file is built, the CEPC environment can be started by booting either from a
floppy or hard drive configured with a Windows 9x operating system. The two methods are
described below.
1. To start CEPC from a floppy drive:
a. Create a bootable floppy disk.
b. Copy himem.sys to the floppy disk and edit config.sys on the floppy disk to con-
tain only the following line:
device=a:\himem.sys
c. Edit autoexec.bat on the floppy disk to contain the following lines:
loadcepc /B:38400 /C:1 c:\nk.bin
d. Search for loadcepc.exe in the Windows CE directories and copy loadcepc.exe to
the bootable floppy disk.
e. Copy nk.bin to c:\.
f. Boot the system from the bootable floppy disk.
2. To start CEPC from a hard drive:
a. Search for loadcepc.exe in the Windows CE directories and copy loadcepc.exe to
C:\.
b. Edit config.sys on the hard drive to contain only the following line:
device=c:\himem.sys
c. Edit autoexec.bat on the hard drive to contain the following lines:
loadcepc /B:38400 /C:1 c:\nk.bin
d. Copy nk.bin to c:\.
e. Boot the system.