Filter
Top Products
Page 48 Epson Research and Development
Vancouver Design Center
S1D13708 Programming Notes and Examples
X39A-G-003-01 Issue Date: 01/11/20
ADVANCE
D
IN
F
ORMATION
Subje
ct to C
ha
nge
8.3 Picture-In-Picture-Plus Examples
8.3.1 SwivelView 0° (Landscape Mode)
Figure 8-2: Picture-in-Picture Plus with SwivelView disabled
SwivelView 0
° (or landscape) is a mode in which both the main and PIP
+
window are non-
rotated. The images for each window are typically placed consecutively, with the main
window image starting at address 0 and followed by the PIP
+
window image. In addition,
both images must start at addresses which are dword-aligned (the last two bits of the
starting address must be 0).
Note
It is possible to use the same image for both the main window and PIP
+
window. To do
so, set the PIP
+
Line Address Offset register (REG[81h],REG[80h]) to the same value
as the Main Window Line Address Offset register (REG[79h],REG[78h]).
PIP+ window
main-window
PIP+ window y start position
panel’s origin
PIP+ window y end position
PIP+ window x start position
PIP+ window x end position
0° SwivelView
TM
(REG[85h],REG[84h])
(REG[8Dh],REG[8Ch])
(REG[91h],REG[90h])
(REG[89h],REG[88h])