Filter
Top Products
• Click Next to configure the port mode for ports in expansion module 2.
• If you do not wish to configure the port mode for ports on the remaining expansion modules, continue
with Step 9.
If you change the port mode for a previously configured port, the port returns to an unconfigured state.
Step 8
If you need to configure port modes for expansion module 3, repeat Step 7.
Step 9
Click Finish to save your port mode configuration.
Depending upon the module for which you configured the port modes, data traffic for the Cisco UCS domain
is interrupted as follows:
• Fixed module—The fabric interconnect reboots. All data traffic through that fabric interconnect is
interrupted. In a cluster configuration that provides high availability and includes servers with vNICs
that are configured for failover, traffic fails over to the other fabric interconnect and no interruption
occurs.
It takes about 8 minutes for the fixed module to reboot.
• Expansion module—The module reboots. All data traffic through ports in that module is interrupted.
It takes about 1 minute for the expansion module to reboot.
Configuring the Beacon LEDs for Unified Ports
Complete the following task for each module for which you want to configure beacon LEDs.
Procedure
Step 1
In the Navigation pane, click the Equipment tab.
Step 2
On the Equipment tab, expand Equipment > Fabric Interconnects > Fabric_Interconnect_Name.
Step 3
Depending upon the location of the unified ports for which you want to configure the beacon LEDs, click on
one of the following:
• Fixed Module
• Expansion Module
Step 4
In the Work pane, click the General tab.
Step 5
In the Properties area, click one of the following radio buttons in the Beacon LED field:
• Off—All physical LEDs are off.
• Eth—The physical LEDs next to all Ethernet ports are on.
• Fc—The physical LEDs next to all Fibre Channel ports are on.
Step 6
Click Save Changes.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
84 OL-25712-04
Unified Ports on the 6200 Series Fabric Interconnect